Triplett 1101a Instrukcja Użytkownika Pobierz pdf (Strona 17)

7.5 Continuity Beeper:

WARNING!

Do not apply voltage or current to the meter when it is set

to the Diode Test / Continuity Beeper mode .

7.5.1 Connect the black test lead to the COM jack and the red test lead to

the V/Ω /mA / F jack.

7.5.2 Set the RANGE switch to the

range.

7.5.3 Connect the test probes to the device or circuit to be tested.

7.5.4 If the resistance of the device or circuit is less than approximately 30

Ohms, the continuity beeper will sound.

Note: The reading displayed on the LCD is not an accurate indication of the

resistance of the device or circuit being measured.

7.6 Diode Test:

WARNING!

Do not apply voltage or current to the meter when it is set

to the Diode Test / Continuity Beeper mode .

7.6.1 Connect the black test lead to the COM jack and the red test lead to

the V/Ω /mA / F jack.

7.6.2 Set the RANGE switch to the

range.

7.6.3 Connect the test probes to the device or circuit to be tested. To test a

simple diode, connect the red test probe to the Anode of the diode and

the black test lead to the Cathode ("banded" end) of the diode. The

LCD will indicate the relative voltage drop of the diode. Reverse the

connections of the test probes to the diode. The LCD should indicate

overrange ("1 - - -"). If the Continuity Beeper sounds when the leads

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Brak uwag

Triplett 1101a Instrukcja Użytkownika Strona 17