Triplett 9007 Instrukcja Użytkownika Pobierz pdf (Strona 26)

Page 25

7.4 AC Voltage Measurement:

WARNING!

If the magnitude of the voltage to be measured is unknown, always

start by setting the meter to the highest range, and then to lower

ranges, until a satisfactory reading is obtained.

Do not rotate the RANGE switch with the input applied to the meter.

If the input voltage is higher than 700VAC (CAT I, CAT II, CAT III), or

600VAC (CAT IV), do not attempt to measure!

Use Caution when measuring voltages above 30V AC.

7.4.1 Connect the black test lead to the COM jack and the red test

lead to the VOLT / DIODE / OHM / CAP “V Ω CAP” jack.

7.4.2 Set the RANGE switch to a V~ position. If the magnitude

of voltage is unknown, set the RANGE switch to the highest

V~ position. If the input voltage is higher than the previously

stated limits, do not attempt to measure!

7.4.3 Connect the test probes to circuit being measured. The LCD will

display the AC voltage.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Brak uwag

Triplett 9007 Instrukcja Użytkownika Strona 26